First Name *
Last Name *
Email Address * Please leave this field empty.
Projected Yearly Volume?
Number of Laminations per stack
End Laminations ---YesNoUnknown
End Laminations Material
Lamination OD and ID
Number of Slots
Magnet Wire Gage
Magnet Wire Coating
Number of Lead Wires, Style, and Gage
Slot Fill % and Slot Area
Stack Insulation ---EpoxySlot LinersUnknown
Thermal Sensor Required? ---YesNoUnknown
If yes, what type?
Number in Hand/Parallel Turns
Number of Coils
Connection Type ---SolderBrazedCrimpedThermal FusingOtherUnknown
Connection Insulation ---TapeTubingSleevingOtherUnknown
Stack, Outer Diameter, Inner Diameter and Height
Coil End-turn Outer Diameter, Inner Diameter and Height
Magnet Material and Grade
Sleeve Required? ---YesNoUnknown
If yes, which material?
Magnet Bonding Type?
Filler Between Magnets? ---YesNoUnknown
If yes, type?
Finished OD of magnets/sleeve and overall shaft length
Balancing Required? ---YesNoUnknown
If yes, specification?
Magnets surface-mounted or embedded? ---Surface-MountedEmbeddedUnknown
Mounting Face Bolt Circle
Mounting Pilot Diameter
Mounting Heat Sink Size
Shaft Side Load and End Load?
Power Supply Voltage Available?
Rated Speed (RPM)
Peak Speed (RPM)
Km, Kt, Ke, and/or Kv
Is Low Torque Ripple Important? ---YesNoUnknown
Feedback Device? ---YesNoUnknown
If yes, type?
Desired Maximum Diameter or square dimensions of housing?
Desired Maximum overall length?
Output Shaft Length from Mounting Face
Electrical Interface? (Leads, Terminal Block, Connector, etc.)
Will you be providing any materials? ---YesNoUnknown
If yes, which materials?
Other Important Considerations?
Validation Testing Needed?